Link MC5 User Manual page 13

Installing the MCs
After the MCs' s operating screen appears, enter setup mode. If this is the very first
time the terminal has been turned on, press
Select
on the EPC/IEPC keyboard,
left
Shift Setup
on the ASCII keyboard, or
F3
on the ANSI keyboard. The
General Setup
menu appears. Table 1-1 lists the setup mode's keyboard commands. The parameters
you see in this and the other menus are set with their factory defaults. Chapter 2
provides information about selecting different parameter values.
If the terminal's emulation has been changed to a different value other than the
default (VT220-7), then refer to Table 1-2 for the keystsrokes that will invoke setup
when another emulation is being used.
lod
r
or
--7
Tab
p
D
s
R
E
MCs User's Guide
Table 1-1. Setup Keyboard Commands
Used to highlight the desired setup parameter.
Used to select a setup parameter's setting.
Moves the highlight to the opposite parameter column.
Switches to the setup parameters for the other
communications port. (Default is MAIN port.)
Restores the factory settings.
Saves the current settings in non-volatile memory. The
settings that were saved last will be in effect at the next
power-up.
Restores the most recently saved settings.
Exits setup mode. If the current setup is not saved, the
changes will be lost when the terminal is turned off.
1-3