Pre-assembly
PLANNING ASSEMBLY
Estimate installation time: Two hours
Number of people required: 4 people
To ensure your installation goes smoothly, please read these instructions carefully and review the recommended tools and hardware before
you begin.
To remove the old vanity (if applicable): 1) Turn off the water supply and drain out. 2) Disconnect the supply lines from the faucet.
3) Remove the old vanity top and vanity. If the new vanity is not installed immediately, temporarily stuff a rag into the drain pipes.
Using a level locate any uneven oor and/ or wall areas where your vanity will be installed. Unevenness can cause your vanity to become
misaligned resulting in twisting of the cabinet. Repair any uneven areas by reducing high spots or shimming low spots.
TOOLS REQUIRED
NOTE: Tools are not included.
Electric
drill with
#2 drill bit
Safety
goggles
HARDWARE INCLUDED
NOTE: Hardware not shown to actual size
Part
AA
BB
CC
Phillips
screwdriver
Description
Wall cleat
Screw
Plastic plug
Quantity
4
16
16
5
Please contact 1-800-986-3460 for further assistance.
Tape
measure
Level
HOMEDEPOT.COM/HOMEDECORATORS