Connecting To Line Output Terminals - Yamaha YST-SW300 Owner's Manual

CONNECTING TO LINE OUTPUT (PIN JACK) TERMINALS OF THE AMPLIFIER
• Leave the main speakers connected to the amplifier.
1 CONNECTING TO PRE OUT OR SUBWOOFER OUT TERMINAL(S)
• Amplifier line output terminals are generally labeled PRE OUT or SUBWOOFER OUT.
* For PRE OUT terminal connection, the amplifier must possess at least two sets of PRE OUT terminals. With some amplifiers
with only one set of PRE OUT terminals, connection can result in no sound from the main left and right speakers. In this case,
select the method of connecting to the speaker terminals.
• To connect with a YAMAHA DSP amplifier, connect the LOW PASS (or SUBWOOFER etc.) terminal on the rear of the DSP
amplifier to either the left (L) or right (R) INPUT 2 terminal.
To connect one unit only
Left speaker
Amplifier
To connect two units
Left speaker
This unit
OUTPUT
TO SPEAKERS
FROM AMPLIFIER
INPUT1
To AC outlet
Notes
• When connected to line output terminals of the amplifier, other speakers should not be connected to the OUTPUT terminals on
the rear panel of this unit. If connected, they will not produce sound.
• When connecting to a monaural line output terminal of the amplifier, connect to either the left or right INPUT 2 terminal.
8
This unit
OUTPUT AUTO PHASE INPUT2 H.P.F.OUTPUT
TO SPEAKERS
POWER
80Hz
ON OFF NOM REV 50Hz I00Hz
FROM AMPLIFIER
INPUT1
To AC outlet
AUTO PHASE INPUT2 H.P.F.OUTPUT
POWER
80Hz
ON OFF NOM REV 50Hz I00Hz
This unit
AUTO PHASE INPUT2 H.P.F.OUTPUT
POWER
80Hz
ON OFF NOM REV 50Hz I00Hz
To AC outlet
AUTO PHASE INPUT2 H.P.F.OUTPUT
POWER
80Hz
ON OFF NOM REV 50Hz I00Hz
<
YAMAHA DSP amplifier
LOW PASS
(SUBWOOFER)
< >
Amplifier
PRE OUT
(SPLIT, SUBWOOFER)
AUTO PHASE INPUT2
POWER
ON OFF NOM REV
OUTPUT AUTO PHASE INPUT2 H.P.F.OUTPUT
TO SPEAKERS
POWER
80Hz
ON OFF NOM REV 50Hz I00Hz
FROM AMPLIFIER
INPUT1
(SPLIT, SUBWOOFER)
Amplifier
>
Pin plug cords
H.P.F.OUTPUT
Pin plug
80Hz
50Hz I00Hz
cords
PRE OUT
Right speaker
Right speaker