Controls And Their Functions - Yamaha YST-SW300 Owner's Manual

CONTROLS AND THEIR FUNCTIONS

Side panel
POWER
VOLUME
0 I0
HIGH CUT
40Hz I40Hz
TONE
MUSIC MOVIE
1
POWER indicator
Lights in green when the POWER switch is turned ON,
and goes off when turned OFF.
* Standby mode
If the AUTO POWER ON/OFF switch on the rear panel
is set to ON, this indicator lights in red when no signal
is input to this unit.
2
POWER switch
Turns the power of this unit ON and OFF whenever
pressed. When this switch is turned ON, the POWER
indicator over the POWER switch lights up.
3
VOLUME control
Adjusts the volume level.
4
HIGH CUT control
Adjusts the high frequency cut off point.
Frequencies higher than the frequency selected by this
control are all cut off (and not output).
* One graduation of this control represents 10 Hz.
80
70
60
50
40 Hz
Rear panel
1
2
3
4
5
90
I00
II0
I20
I30
I40 Hz
6
OUTPUT AUTO
TO SPEAKERS POWER
ON OFF
FROM AMPLIFIER
INPUT1
7 8
5
TONE control
Used to increase or decrease the low frequency response.
Turn this clockwise (toward the MOVIE position) to
increase the low frequency response.
Turn this counterclockwise (toward the MUSIC position) to
decrease the low frequency response.
TONE
MUSIC MOVIE
6
OUTPUT (TO SPEAKERS) terminals
Can be used for connections with the main speakers.
These terminals send signals output from the amplifier to
the main speakers directly.
7
INPUT1 (FROM AMPLIFIER) terminals
Used to connect this unit with the speaker terminals of the
amplifier.
PHASE INPUT2 H.P.F.OUTPUT
80Hz
NOM REV 50Hz I00Hz
9 0 A B
FREQUENCY
CHARACTERISTICS
50 Hz
MOVIE
CENTER
MUSIC
11