Table of Contents
Advertisement
CONTROLS
with the device, they may not function
correctly. There is a risk of injury and
risk of damage to property. When charg-
ing mobile devices, make sure there are
no objects on the tray together with the
device.
NOTICE
The tray is intended for mobile phones up
to a particular size. Forceful inserting of
the mobile phone into the tray can damage
the tray or the mobile phone. There is a
risk of damage to property. Observe the
maximum dimensions for mobile phones.
Do not force the mobile phone into the
tray.
Functional requirements
–
Ignition or standby state is switched on.
–
The mobile phone must compatibly sup-
port the required Qi standard. Compati-
ble mobile phones, refer to page 52.
If the mobile phone does not support the
Qi standard, the mobile phone can be
charged using a special Qi-compatible
charging case.
–
Use only protective sleeves and cov-
ers up to a maximum thickness of
0.07 in/2 mm. Otherwise, the charging
function may be impaired.
–
The mobile phone must not exceed the
maximum size of approximately 5.9 x
3.07 x 0.62 in/150 x 78 x 16 mm.
Overview
The wireless charging tray is located in the
center armrest.
206
Interior equipment
Online Edition for Part no. 01405A7D6C6 - II/23
1 Front holder with LED
2 Storage area
3 Movable retaining clip
Inserting the mobile phone
1.
Open the center armrest.
2.
Push back the retaining clip.
3.
Insert the mobile phone with the display
facing upward in the direction of the
front holder, arrow 1.
4.
Place the mobile phone in the storage
area, arrow 2.
5.
Push the retaining clip forward and clip
the mobile phone in the tray.
6.
Close the center armrest.
Removing the mobile phone
1.
Open the center armrest.
2.
Push the retaining clip back and remove
the mobile phone.
Advertisement
Table of Contents
