Mini COOPER SE Owner's Manual page 163

Hide thumbs Also See for COOPER SE:
Table of Contents

Advertisement

When the speed limit is activated, Dynamic
Stability Control is switched on as neces-
sary.
Turning off
Press the button on the steering
wheel.
The system switches off automatically in
the following situations, for example:
When shifting into reverse gear.
When drive-ready state is switched off.
When Cruise Control is switched on.
When activating Dynamic Traction Con-
trol or deactivating Dynamic Stability
Control.
The displays turn off.
Changing the speed limit
or
button: press up or down repeat-
edly until the desired speed limit is set.
or
button: each time it
is pressed to the resistance point, the
speed limit increases or decreases by
1 mph, 1 km/h.
or
button: each time it is
pressed past the resistance point, the
desired speed changes by a maximum of
5 mph/10 km/h.
When the speed limit is set during a trip to
a value below the current speed, the vehicle
coasts until it drops to the set speed limit.
Exceeding the speed limit
The speed limit can be exceeded intention-
ally.
Press the accelerator pedal all the way down
to intentionally exceed the set speed limit.
When the vehicle speed drops below the
set speed limit, the limit is automatically
reactivated.
Online Edition for Part no. 01405A7D6C6 - II/23
Safety
Warning when the speed limit is
exceeded
Visual warning
If the set speed limit is exceeded, the LIMIT
or LIM indicator flashes while the vehicle
speed is greater than the speed limit.
Acoustic warning
If the speed limit is exceeded uninten-
tionally, a signal sounds.
When the speed limit is reduced to be-
low the vehicle speed while driving, a
signal sounds after approx. 30 seconds.
When the speed limit is intentionally
exceeded by stepping on the accelerator
pedal all the way down, there is no sig-
nal.
Displays in the instrument cluster
The desired speed is displayed
under the LIM indicator.
The indicator does not illuminate: the
system is switched off.
The indicator illuminates green: the sys-
tem is active.
Display flashes green: set speed limit ex-
ceeded.
Displays in the Head-up display
The information from the Speed Limiter can
also be displayed in the Head-up display.
CONTROLS
163

Advertisement

Table of Contents
loading

Table of Contents