Table of Contents
Advertisement
Press the Right Arrow key to move to the next setting. The Soft Air LED will remain on.
However you are now setting the Vent Off time.
4. Using the Plus/Minus keys set the amount of time you want the vent valve to remain
closed between each vent pulse.
5. Press the Up Arrow key to return to normal operation mode.
3.4.2 Setting the Parameters for the Optional Settings
Important Note: These settings will only function if the options they pertain to
were purchased. Refer to figure 6 below to help you complete these settings.
PROGRAM
STB W O RK V A C
G A S SEA L1 SEA L2 CO O L SO FT
O I L CH G
Gas On / Off /Pulse LED
A. Gas Flush
1. Prepare to make changes as instructed in point D
2. Press the Left Arrow key until the Gas LED is lit.
3. Using the Plus /. Minus keys set the amount of time you want gas to enter the
chamber.
Figure 6
TIME / %
G A S
A I R
O N / O FF
PU LSE
Purge
Gas On / Off
10
PRO G RA M
SH I FT
PU RG E
Pulse On / Off
SK I P
STO P
CY CLE
CY CLE
G A S
PU LSE
O N / O FF
O N / O FF
PO W ER O N
PO W ER O FF
Advertisement
Table of Contents
