ITW SIMCO-ION IQ EASY MODULAR SENSOR Installation And Operating Instructions Manual page 12

RJ-45-Style Connector
1. Insert the RJ-45 cable into the RJ-45 connector on the input side (the input side is the same side as the LEDs).
2. Route the other end of the lead cable to the Control Station. Remove one of the RJ-45 connector dust covers and
connect the RJ-45 cable to the control station.
3. Route the cable away from any moving machine parts and secure the cable to prevent damage.
4. If connecting more than one sensor, either remove the rear connector label and connect a separate RJ-45 cable to
the opposite end of the lead sensor (non-LED end) or connect the sensor directly to the control station, following
the same process as the first sensor.
5. See Section 8, Parts and Accessories for available cables.
NOTE! – Do not use any Ethernet cables. Use only modular cable terminated, as shown above. The use of
Ethernet cables may cause equipment failure or damage.
IQ EASY MODULAR SENSOR
Figure 8: RJ-45 IQ Easy Modular Sensor Crossover Modular Cable (black)
10
5201337 REV A