Yamaha UMAX Service Manual page 45

1. Wire harness
2. Fuel hose
3. Fuel pump coupler
4. Intake air temperature sensor
5. Plastic band
6. Voltage regulator
7. Fuel pump relay
8. Positive battery lead
9. Negative battery lead
10. Accelerator switch coupler
11. Main switch
12. Ground lead
13. Main relay
14. Starter generator
15. Engine oil level switch lead
16. Rear brake cable (right)
17. Accelerator switch
18. Horn switch
19. Horn switch lead
A. Install the intake air temperature sensor
completely into the grommet.
B. Make sure that there is no slack in the wire
harness.
C. Fasten the wire harness at the white tape to the
frame with the plastic band.
D. Route the engine oil level switch lead between the
starter generator and the starter generator bracket.
2-22
CABLE ROUTING