Recommendations On Use; Maintenance - Atlantic 831405 Manual

- It is useless to set the device to maximum power, the bathroom temperature will not rise any fas-
ter.
- If you will be away for more than 48 hours : set the mode selection wheel A to ON and the tem-
perature setting wheel D to
Your device will keep the temperature at 7°C (±3° C).
- Switch off the device before any maintenance is performed.
- To maintain the performance of the device, about twice per year, clear the dust.
Do not use abrasive products.
- Devices with this symbol should not be disposed of with normal household rubbish but
instead must be collected separately and recycled.
The collection and recycling of products at the end of their service life must be carried
out in accordance with the local regulations.
Problems Encountered
The device does not heat - Ensure that the main circuit breakers are closed or that the overload
The device heats all the
time
R
ECOMMENDATIONS OF USE
.
M
AINTENANCE
I
N CASE OF PROBLEM
cut-out has not cut off the supply to the advice.
- Check the air temperature in the room : if it is too high, the heating
light C does not come on: the device does not heat.
- Switch your heating OFF and then ON again with the mode selection
wheel A :
• If the indicator light C flashes constantly (continuous flashing): the
measuring sensor is defective. Contact the manufacturer's local After-
Sales service in order to replace it.
- Ensure that the device is not locked in the Frost-Free position.
- Check that the device is not locked onto a low temperature. If this is
the case, unlock the device and increase the temperature using the
temperature setting wheel D (see page 18).
- Check that the device is not located in a draft or that the tempera-
ture setting has not been changed.
- There may be a fluctuation in the electricity supply. If you experience
a problem (thermostat locked, ...), cut off the electricity supply to the
towel-dryer (via the fuse or circuit breaker) for approx. 10 minutes and
the switch it on again.
- If you encounter the same phenomenon frequently, have your power
supply checked by your local utility.
- Check that the device is not locked onto too high a temperature. If
this is the case, unlock the device and reduce the temperature using
the temperature setting wheel D (see page 18).
Checks to be made
20