Table of Contents
Advertisement
9. Maintenance
9.1 Safety
To avoid damage to the machine or life-threatening injuries during maintenance of the TEBI 3.0, the following
points must be strictly observed:
•
Turn off the TEBI 3.0 using the On/Off switch and unplug the power cord.
•
Maintenance work should only be performed by authorized personnel with adherence to safety regulations.
•
Use only spare parts listed in our spare parts list.
•
Repairs should only be carried out by the service personnel of esmatec GmbH (Service address as mentioned
in Chapter 1).
•
If specified, use the prescribed special tools (included in the delivery) during maintenance.
•
Always read the safety instructions in Chapter 1.
9.2 Maintenance Schedule
Activity
Clean casing
Before each startup
Replace milling cutter
9.3 Changing the cutter
•
Turn off the TEBI 3.0 using the On/Off switch (1).
EN
Maintenance interval
Weekly
Check safety devices
Poor or unclean chamfer
14
Actions to be performed
Clean the casing or covers with a
neutral cleaning agent.
Verify that the safety devices are
fully applied, secured, and
undamaged.
Follow the procedure for replacing
the milling cutter as described
in the subsequent Chapter 9.3.
Advertisement
Table of Contents
