Table of Contents
Advertisement
6.2 Electrical Connection of the TEBI 3.0
The electrical connection of the TEBI 3.0 is made via the power cable with the Schuko plug to 230V (pre-fuse
16A). Local regulations and legal requirements must be observed.
WARNING!
!
Dangerous electrical voltage!
6.3 Using the TEBI 3.0
Before using or turning on TEBI 3.0, ensure the following points are met:
•
The TEBI 3.0 must be securely positioned.
•
The TEBI 3.0 must be connected to 230V via the Schuko plug (pre-fuse 16A).
•
Foreign objects or tools on the TEBI 3.0 must be removed.
7. Operation
7.1 Safety
To avoid machine damage or life-threatening injuries during the operation of the TEBI 3.0, the following points
must be strictly observed:
•
The TEBI 3.0 should only be used/deployed according to its intended purpose (see Chapter 2).
•
Familiarize yourself with the correct procedures in case of malfunctions before turning on the TEBI 3.0 (refer
to Chapter 8).
•
Inspect the protective devices/coverings on the TEBI 3.0 before switching it on.
•
If a "malfunction" occurs, the TEBI 3.0 must be shut down immediately.
7.2 Before Turning On the TEBI 3.0
•
Put on the safety goggles (eye protection).
•
Ensure that no objects are on the machine, and the housing is not damaged.
7.3 Turning On the TEBI 3.0, Adjusting, and Feeding the Workpiece
To set up the machine for the workpiece, follow these steps:
WARNING!
There is a risk of injury due to the rotating milling head during the following tasks!
Never reach into the rotating milling head!
MANDATORY
When working on the TEBI 3.0, wearing safety goggles is mandatory!
EN
10
Advertisement
Table of Contents
