Functional Overview; Front Panel; Rear Panel - Philips BDP5320 User Manual

FUNCTIONAL OVERVIEW

Front Panel

1
* The unit can also be turned on by pressing these buttons.
1. Q (standby/on) button
• Press to turn on the unit, or to turn the unit into the
standby mode. (To completely turn off the unit, you
must unplug the AC power cord.)
• Press and hold for 10 seconds to shut down the unit.
• This button lights up in red when the unit is in
standby mode and turns off when the power is on.
2. C (stop) button
• Press to stop playback.
3. F (pause) button
• Press to pause playback.
4. B (play) button*
• Press to start or resume playback.
5. A (open/close) button*
• Press to open or close the disc tray.

Rear Panel

1 2
LAN
HDMI OUT
Wireless LAN
6
1. LAN terminal
• Use to connect a modem with LAN cable.
2. HDMI OUT jack
• Use to connect to a display with an HDMI compatible
port with an HDMI cable.
3. AUDIO OUT jacks
• Use to connect a TV monitor, an AV receiver /
amplifier or other device with an RCA audio cable.
4. COMPONENT VIDEO OUT jacks
• Use to connect a TV monitor with component video
inputs with an RCA component video cable.
5. AC power cord
• Connect to a standard AC outlet to supply power to
this unit.
• Unplug this cord from the AC outlet to completely
turn off the unit.
2 3 4* 5* 6
4
3
Y P C
R / R
L
P / C
B B
R
COAXIAL AUDIO VIDEO COMPONENT
OUT VIDEO OUT
DIGITAL OUT OUT
PCM/BITSTREAM
7
8
7
6. Disc tray
• Place a disc after opening the disc tray.
7. Display
• Refer to "Front Panel Display" on page 14.
8. Infrared sensor window
• Receive signals from your remote control so that you
can control the unit from a distance.
9. SD card slot
• Insert an SD Memory Card and play back the
contents in it.
Note
• This unit will be turned into the standby mode
automatically after 25 minutes of no action.
6. Wireless LAN terminal
• Use to connect the supplied USB wireless LAN
adapter.
7. DIGITAL OUT (COAXIAL) jack
• Use to connect an AV receiver / amplifier, Dolby
Digital / DTS decoder or other device with a digital
audio coaxial input jack with a digital audio coaxial
cable.
8. VIDEO OUT jack
• Use to connect a TV monitor, an AV receiver /
amplifier or other device with an RCA video cable.
Note
• Do not touch the inner pins of the jacks on the rear
panel. Electrostatic discharge may cause permanent
damage to the unit.
• This unit does not have the RF modulator.
• Do not insert a USB flash memory to the Wireless LAN
terminal. This unit is not designed to play back data
in USB flash memory.
8 9
5
EN 11
EN