Picture Settings Table - JVC LT-32CA120 Instruction Manual

Picture Settings Table

The following table show all the available picture setting adjustment on your TV. Not all of these setting apply to all Inputs.
Your TV has some pre-set picture modes: STANDARD - VIVID - SPORT - MOVIE - GAME. The default setting
Picture Mode
is STANDARD. You can also manually adjust the picture by choosing USER.
The Auto Backlight setting in set to Eco as default, but it can also be changed to OFF - LOW - MIDDLE -
Auto Backlight
ECO.
To access Backlight you must first switch off Auto Backlight. Increases or decreases the brightness of the
Backlight
backlight from 0 - 100.
Brightness Increases or decreases the picture brightness from 0 - 100.
Contrast
Increases or decreases the picture contrast from 0 - 100.
Colour Increases or decreases the colour from 0 - 100.
HUE Increases or decreases the hue from 0 - 100.
Sharpness
Increases or decreases the picture sharpness from 0 - 20.
Gamma Choose from Dark, Middle (standard) or Bright. Highlight your desired setting then press OK.
The colour temperature setting has 4 preset settings USER - COOL - STANDARD - WARM, when selected
Colour
each of these settings has individual adjustments. Red, Green and Blue gain can all be adjusted from -100
Temperature
to 100.
Advanced
Select to have more advanced adjustments to your TVs picture.
Video
DNR (Dynamic
Noise Reduction)
MPEG NR (Noise
Reduction)
Adaptive Luma
Control
DI Film Mode
Blue Stretch
Game Mode
PC Mode
HDMI RGB Range
(HDMI input only)
Colour Tuner can be switched on and off by selecting ENABLE ON or OFF. Then you have 5 separate
Colour Tuner
setting that can be individually adjusted. HUE - SATURATION - BRIGHTNESS - OFFSET - GAIN.
11 Point Colour
This setting enables you to calibrate the white balance of your TV. With 11 Point Colour Correction
Correction enabled, you can adjust Gain from 5% to 100% and also adjust the Red, Green and Blue levels.
Reset to Default Resets all setting to factory default settings.
Dynamic Noise Reduction has 5 different setting OFF - LOW - MEDIUM - STRONG
- AUTO. The default setting is MEDIUM. Highlight your desired setting then press
SELECT.
MPEG Noise Reduction has 4 different setting OFF - LOW - MEDIUM - STRONG. The
default setting is MEDIUM. Highlight your desired setting then press SELECT.
Adaptive Luma Control has 4 different setting OFF - LOW - MEDIUM - STRONG. The
default setting is MEDIUM. Highlight your desired setting then press SELECT.
DI Film mode has 2 setting AUTO and OFF. The default setting is OFF. Highlight your
desired setting then press SELECT.
Blue Stretch can be switched ON or OFF.
Game Mode can be switched ON or OFF.
PC Mode can be switched ON or OFF.
HDMI RGB Range has 3 different settings AUTO - FULL - LIMIT. The default setting is
AUTO. Highlight your desired setting then press SELECT.
Customising TV Settings
5
37