Table of Contents
Advertisement
Preparation
2
Installing / Removing the Stand
The LCD display is very fragile, and must be protected at all times when installing and removing the base stand. Be sure that
no hard or sharp object, or anything that could scratch or damage the LCD display, comes into contact with it. DO NOT exert
pressure on the front of the TV at any time because the screen could crack.
Fitting the Stand
1. Ensure the TV is switched off and not connected to the mains power supply.
2. Lay the TV down on a flat surface ideally on the edge of a table so the base of the TV slightly overhangs the edge of the table,
with the back side facing up. Please make sure a soft cushioned material (such as a dry bath towel or thick piece of foam) is
placed beneath the screen.
3. Fit each leg to your TV using the screws supplied.
Cushioned
material
10
LAN
VGA
SPDIF
Optic.OUT
AV IN
Protective
Table
bag
LAN
VGA
SPDIF
Optic.OUT
AV IN
Advertisement
Table of Contents
