Table of Contents
Advertisement
Preparation
2
Installing / Removing the Base Stand
The LCD display is very fragile, and must be protected at all times when installing and removing the base stand. Be sure that
no hard or sharp object, or anything that could scratch or damage the LCD display, comes into contact with it. DO NOT exert
pressure on the front of the TV at any time because the screen could crack.
Fitting the Neck and Neck Cover
Together
1. Fit the neck cover over the neck.
2. Using 2 of the supplied screws (A), screw the neck
and neck cover together.
Fitting the Neck and Stand to the TV
Table
3. Ensure the TV is switched off and not connected to the mains power supply.
4. Lay the TV down on a flat surface ideally on the edge of a table so the base of the TV slightly overhangs the edge of the table,
with the back side facing up. Please make sure a soft cushioned material (such as a dry bath towel or thick piece of foam) is
placed beneath the screen. You can leave the protective bag on to protect the TV at this point.
5. Slide the Neck and Neck cover under the lip, the neck will fit snugly over the screw holes. Then screw the Neck to the TV using
the 6 screws (B) supplied.
6. Once the Neck is secure screw the base to the neck using the 3 screws (A) supplied. Be careful not the drop the base, its heavy.
8
JVC 43' LED Smart 4K HDR TV LT-43C888 Manual.indd 8
B
Cushioned
A
material
A
A
Protective
bag
22/02/2018 10:29
Advertisement
Table of Contents
