Yamaha RX-V1700 Owner's Manual page 38

AUTO SETUP
Volume level LEVEL
Checks and adjusts the volume level of each speaker.
Choices: CHECK, SKIP
• Select "CHECK" to automatically check and adjust
this item.
• Select "SKIP" to skip this item and perform no
adjustments.
8
Press n to select "START" and then press
ENTER to start the setup procedure.
This unit starts the auto setup procedure. Loud test
tones are output from each speaker during the auto
setup procedure. Once all items are set, the
"RESULT:EXIT" display appears in the OSD.
PRESET/CH
ENTER
A-E/CAT.
Notes
• During the auto setup procedure, do not perform any
operation on this unit.
• We recommend getting out of the room while this unit is in
the auto setup procedure. It takes approximately 3 minutes
for this unit to complete the auto setup procedure.
The display changes as follows.
1 AUTO:MENU
SETUP;;;;;;;AUTO
WIRING;;;;;CHECK
DISTANCE;;;CHECK
SIZE;;;;;;;CHECK
EQ;;;;;;;NATURAL
LEVEL;;;;;;CHECK
. START
[ ]/[ ]:Up/Down
p
[ ]/[ ]:Adjust
2 AUTO:CHECK
INITIALIZING
. PRE CHECK
MAIN CHECK
EQUALIZING
LEVEL
CHECK CH=CENTER
|||||;;;;;;;;
[ ]: Exit
RESULT:EXIT
. RESULT
.
SP
.
DIST: 14.0/ 17.0ft
.
LVL : -9.0/ +6.5dB
[
SET CANCEL
[ ]/[ ]:Up/Down
[ENTER]:Enter
34
En
PRESET/CH
ENTER
A-E/CAT.
[
: 5/4/0.1
The results displayed under "RESULT" are as
follows.
Number of speakers SP
Displays the number of speakers connected to this
unit in the following order:
Front/Back/Subwoofer
Speaker distance DIST
Displays the speaker distance from the listening
position in the following order:
Closest speaker distance/Farthest speaker distance
Speaker level LVL
Displays the speaker output level in the following
order:
Lowest speaker output level/Highest speaker output
level
Notes
• If "E-10:INTERNAL ERROR" appears during the testing
procedure, restart from step 4.
• If you selected "RELOAD" in step 4, no test tones are
output.
• If an error occurs during the "AUTO:CHECK" procedure,
the setup procedure is canceled and an error screen
appears. For details, see "If an error screen appears" on
page 36.
• When this unit detects potential problems during the
"AUTO SETUP" procedure, "WARNING" and the
number of warning messages appears in the above of
"RESULT" (see page 37).
• Depending on the listening environment, "SWFR
PHASE:REV" appears during the "AUTO:CHECK"
procedure and "SUBWOOFER PHASE" in "SOUND
MENU" (see page 89) is automatically set to
"REVERSE".