Basic Menu - Yamaha RX-V1700 Owner's Manual

5
Press k / n repeatedly and then press ENTER
to select and enter the desired submenu.
The following display is an example where "LFE
LEVEL" is selected.
PRESET/CH
ENTER
A-E/CAT.
B)LFE LEVEL
. SPEAKER;;;;;;0dB
HEADPHONE;;;;0dB
[ ]/[ ]:Up/Down
p [
[ ]/[ ]:Adjust
6
Press k / n to select the desired parameter
and then l / h to change the parameter
settings.
• Press h to increase the value.
• Press l to decrease the value.
PRESET/CH
ENTER
A-E/CAT.
7
Press SET MENU to exit from "SET MENU".
SET MENU
MENU
SRCH MODE
PRESET/CH
ENTER
A-E/CAT.
PRESET/CH
ENTER
A-E/CAT.
CUSTOMIZING THIS UNIT (MANUAL SETUP)

1 BASIC MENU

Use this menu to manually adjust any speaker settings.
2 BASIC MENU
. A)SPEAKER SET
B)SP LEVEL
C)SP DISTANCE
D)TEST TONE
[ ]/[ ]:Up/Down
[ENTER]:Enter
■ Speaker settings
Use this feature to manually adjust any speaker settings.
y
• If you are not satisfied with the bass sounds from your speakers,
you can change these settings according to your preference.
• When the diameter of the woofer section of the speaker unit is
larger than 16 cm (6.5 in), set the correspondent speaker setting
parameter to "LARGE" (or "LRG").
LFE/Bass out LFE/BASS OUT
Use this feature to select the speakers that output the LFE
(low-frequency effect) and the low-frequency signals.
Choices: SWFR, FRONT, BOTH
LFE/BASS OUT
SWFR FRONT BOTH
• Select "SWFR" (subwoofer) if you connected a
subwoofer. The LFE signals as well as the low-
frequency signals of other speakers set to "SML" (or
"SMALL") are directed to the subwoofer.
• Select "FRONT" (front) if you did not connect a
subwoofer. The LFE signals, the low-frequency signals
of the front left and right channels, and the low-
frequency signals of other speakers set to "SML" (or
"SMALL") are all directed to the front left and right
speakers regardless of the "FRONT SP" setting (see
page 87).
• Select "BOTH" (both) if you connected a subwoofer.
The low-frequency signals of any source are output
from the subwoofer. The LFE signals as well as the
low-frequency signals of other speakers set to "SML"
(or "SMALL") are directed to the subwoofer. The low-
frequency signals of the front left and right channels
are directed to the front left and right speakers and the
subwoofer regardless of the "FRONT SP" setting (see
page 87).
A)SPEAKER SET
[
87
En