Installing Options; Top Case Oes; Bottom Case; Dru-3 Digital Recording Unit - Kenwood TS-870S Instruction Manual

INSTALLING OPTIONS
REMOVING THE CASE
TOP CASE
4 Remove the screws (10 screws).
2. Lift off the top case.
BOTTOM CASE
1 Remove the screws (12 screws).
2 Lift off the bottom case.
DRU-3 DIGITAL RECORDING UNIT
CAUTION: Switch OFF the power and unpiug the DC power cabie
before beginning installation,
Note: Aeter to "INTERNAL ADJUSTMENTS" {page 70} for
information on adjusting the recording level.
EQUIPMENT REQUIRED:
+ Large Phillips screwdriver
* Small Phillips screwdriver
Remove the bottom case (12 screws}.
Remove Cover A (see diagram) (6 screws).
3 Locate the CN5 connector in the transceiver.
Remove the paper backing from one side of the
supplied cushion, then install the cushion. Remove
the paper backing from the other side of the installed
cushion, then plug the DRU-3 connector (CN901)
into CNS.
4 Re-install Cover A (6 screws).
5 Replace the bottom case and re-insiall its screws
(12 screws).
VS-2 VOICE SYNTHESIZER UNIT
CAUTION: Switch OFF the power and unplug the DC power cable
before beginning installation.
EQUIPMENT REQUIRED:
+ Large Phillips screwdriver
+ Small Phillips screwdriver
1 Confirm that the small switch on the VS-2 unit is in
the "ENGLISH" position.
Remove the bottom case (12 screws).
3 Remove Cover A (6 screws).
4 Locate the 8-pin connector CNG in the transceiver,
and plug the VS-2 connector into CN6.
75