Erasing A Tape - JVC DX-MX70BK Service Manual

High-Speed Dubbing
1.
16
Insert the cassette for playback into deck A and the cassette for record-
ing into deck B.
® To change the playback direction of deck A, hold down the Stop © but-
ton and press the <] or & button.
- Press the HIGH SPEED DUBBING button on the Tape Deck.
'tae.
Cc
® The high-speed tape-to-tape recording starts.
Note: You can listen to another source while high-speed dubbing is in
progress.
™ To stop high-speed dubbing before reaching the end of either the play-
back or record tape, press the Stop @ button on deck B.
Note: if a nearby television is on during high-speed dubbing, a beeping
noise may be recorded onto the record tape. Turn off the television or
move it farther away.
. Press the Stop @ button on deck A when you hear the end of a track
to record from many different tapes (for example, to create a ''Greatest
Hits'' tape)
Deck A stops playback, and deck B automatically creates about a 4 se-
cond blank, then pauses.
Note: If you don't want this blank, press the PAUSE Bf button on deck
B before pressing the Stop ™ button.
- Put another tape into deck A.
- Press the HIGH SPEED DUBBING button on the Tape Deck.
The high-speed dubbing restarts.
- To record tracks from other tapes, repeat steps 3 - 5.
® The SEA Function is not effective during high-speed dubbing.
Note: It may be unlawful to record or playback copyrighted material without
the consent of the copyright owner.
| DX-MX70BK
Erasing a Tape
1. Insert the tape to be erased into deck B.
@ To erase music on both sides, set the REV.MODE switch to the auto
reverse position.
2. Press the Pause If button while simultaneously pressing the REC/REC
MUTE button. ©
This puts the deck in REC/PAUSE mode.
3. Press the TAPE button on the Amplifier.
4. Press the <j or > button (depending on which side of the tape you want
to erase) on deck B.
The erasure of the tape begins.
Direct Recording from the CD Player
Direct recording permits a tapedeck to start recording automatically
in synchronism with a CD player.
1. Insert the cassette for recording into deck B.
@ Set the REV.MODE switch to Auto reverse > position if you want
to record on both sides of the cassette.
2. Put a CD in the CD Ptayer.
3. Press the CD DIRECT REC button on the Tape Deck.
@ The CD Player and the Tape Deck are activated, and recording begins
with the first track of the CD.
® To stop direct recording, press the Stop ™ button on deck B or the
STOP/CLEAR button on the CD Player.
4. To fade out the CD gradually at the end of the tape. press the FADE
button on the CD Player.
|
The volume level of the fast track on the tape is lowered gradually to 0.
This makes a nice ending to your tape and prevents an abrupt cut-off of
music if the tape ends before the CD.
5. To cancel the fade-out function during recording, press the FADE foutton
again on the CD Player.
The fade-out function operates in both forward and reverse directions.
® When the end of the tape is reached, the tape is rewound to the
beginning of the last track.
® The last track is played back again from the CD Player and recorded
again on the tape. This time the sound level is reduced gradually at
the end.
Dolby noise reduction and HX PRO headroom extension manufactured under
license from Dolby Laboratories Licensing Corporation. HX PRO origénated
by Bang and Olufsen. ''Dolby'', the Double-D symbol and HX PRO are trade-
marks of Dolby Laboratories Licensing Corporation.