Advertisement
a es
ar
Check that the screws,parts and wires:are put back
PE- 1631E E- A.
os
securely in their original position after repair.Ensure
-~Main unit"
So
1
for safety reasons there is no possibility of secondary -
: Mounting bracket
=
ts
300-9677-00
1
ploblems around the repaired spots.
Parts bag
Mas
—
as
If extended damage is caused due to negligence of
' Hook plate
te
331-0488-00
2
;
repair, the legal responsibility shall be with be re air.
(alternative part
330-8216-01
2)
ing company.
*
eee
Cable tie
335-0833-07
1
4. Caution in removal and making wiring connection to
Spacer
345-3653-01
1
the parts for the automobile.
Screw
716-0726-01
1
Disconnect the battery terminal after turning the igni-
A-lead
850-6688-50
1
tion key off.If wrong wiring connections are made with
DCP case
wi
335-5331-00
1
the battery connected, a short circuit and/or fire may
occur.if extensive damage is caused due to negligence
a To engineers in n charge of repair i
of repair,the legal responsibility shall be with the re-
or inspection of our products. . .
RAIA CONE
Sincere
;
5. Cautions regarding chips.
Before repair or inspection,make sure to fol-
Do not reuse removed chips even when no abnormal-
low the instructions so that customers and -
ity is observed in their appearance.Always replace
Engineers in charge of repair or inspection can
them with new ones.(The chip parts include
resistors,capacitors,
diodes, transistors,etc). The nega-
tive pole of tantalum capacitors is highly susceptible
to heat,so use special care when replacing them and
check the operation afterwards.
6. Cautions in handling flexible PWB
Before working with a soldering iron,make sure that
the iron tip temperature is around 270°C.Take care
not to apply the iron tip repeatedly(more than three
times)to the same patterns.Also take care not to ap-
ply the tip with force.
7. Turn the unit OFF during disassembly and parts
replacement.Recheck all work before you apply power
to the unit.
avoid suffering any risk or injury.
1. Use specified parts.
The system uses parts with special safety features
against fire and voltage.Use only parts with equiva-
lent characteristics when replacing them.
The use of unspecified parts shall be regarded as re-
modeling for which we shall not be liable.The onus of
product liability (PL) shall not be our responsibility in
cases where an accident or failure is as a result of
unspecified parts being used.
MADJUSTMENT ...
FM section
1. Input the 98.1MHz/30dB 7 (400H2- -MOD 30%)signal.
SG
2. Turn on the power switch. and,Press the AF button and CH6 button at the
A
same time.(TEST MODE)
:
3. Adjust the reading of LCD.indicator to [30----00] (3.0V+0.2V) by VR1.
Tape section
SW:OFF)
Adjustment point
( Top side of main unit )
Advertisement
