Husqvarna 330iKE Operator's Manual page 10

In this section the product's safety features,
its purpose and how checks and maintenance
should be carried out to ensure that it
operates correctly. See instructions under
Product overview on page 2 to
the heading
find where these parts are located on your
product.
The life span of the product can be reduced
and the risk of accidents can increase
if product maintenance is not carried out
correctly and if service and/or repairs are not
carried out professionally. If you need further
information please contact your nearest
servicing dealer.
WARNING:
with damaged safety components.
The product's safety equipment
must be inspected and maintained
as described in this section. If your
product fails any of these checks,
contact your service agent to get it
repaired.
CAUTION:
repair work on the machine
requires special training. This is
especially true of the machine's
safety equipment. If your machine
fails any of the checks described
below you must contact your
service agent. When you buy any
of our products we guarantee the
availability of professional repairs
and service. If the retailer who sells
your machine is not a servicing
dealer, ask for the address of your
nearest service agent.
To check the cutting attachment guard
WARNING:
cutting attachment without an
approved cutting attachment guard.
If an incorrect or damaged cutting
attachment guard is installed this
can cause injury.
WARNING:
attachment is attached to a battery
power unit, make sure that the front
guard is installed.
10
Never use a product
All servicing and
Do not use a
If the cutting
• Make sure that the cutting attachment
guard and front guard are not damaged.
Replace the cutting attachment guard and
front guard if they are damaged.
• Only use original spare parts.
To check the blade
The blade is designed and manufactured to
withstand the loads that edging of a lawn
involves.
• Check the blade for damage or cracks.
A damaged blade should always be
replaced.
To check the support flange
• Check that the support flange is not
cracked due to fatigue or due to being
tightened too much. Discard the support
flange if it is cracked.
To check the locknut
CAUTION:
inside the locknut must not be so
worn that you can turn it by hand.
The lining should offer a resistance
of minimum 13 in-lb / 1.5 Nm. The
locknut must be replaced after it
has been put on approximately 10
times.
The nylon lining
2114 - 004 - 03.11.2023