Husqvarna 330iKE Operator's Manual page 16

To connect the battery to the product
WARNING:
original batteries with the product.
1. Make sure that the battery is fully charged.
2. Push the battery into the battery holder of
the product. The battery locks into position
when you hear a click.
CAUTION:
does not move easily into the
battery holder, the battery is
not installed correctly. This can
cause damage to the product.
3. Make sure that the battery is installed
correctly.
Battery information
Refer to the operator's manual of the battery
for information about how to use the battery.
To start the product
1. Put the product in the start position.
2. Push and hold the power button until the
green LED comes on.
3. Use the power trigger to control the speed.
16
Only use Husqvarna
If the battery
To adjust the cutting depth of the
cutting attachment
The cutting depth of the cutting attachment
must be adjusted before starting work.
1. Loosen the wing nut.
2. Set the desired cutting depth.
3. Tighten the wing nut.
Speed mode function
You can use the product in 3 speed modes.
• Eco mode: On the speed mode display
1 LED comes on when you operate the
product. Use the eco mode for easier tasks
and to extend the battery life.
• Normal mode: On the speed mode display
2 LEDs come on when you operate the
product. Normal mode is applicable for
most tasks. The product is set to the
normal mode when started.
• Boost mode: On the speed mode display
all 3 LEDs come on when you operate
the product. Use the boost mode for tasks
where more force is necessary.
Note:
If you release the power trigger, the
product sets to the last speed mode when
you start it again. If the product automatically
stops, the product sets to normal mode when
you start it again.
To select a speed mode
You can set necessary speed mode when you
operate the product.
2114 - 004 - 03.11.2023