Choose Attachment Option - Sears Kenmore W10435038B Instruction Manual

Built-up Floors—Add
shims as needed
Built-up floors: If the kitchen floor is higher than the cabinet
opening's floor - for example, the kitchen floor tile does not
extend into the cabinet opening - add shims as needed in the
area shown to bring the dishwasher up to 33%" (85.1 cm) below
the countertop.
NOTE: Shims must be securely attached to floor to avoid
movement when the dishwasher is in use.
go
Choose Attachment Option
AWARNING
Excessive Weight Hazard
Use two or more people to move and install
dishwasher.
Failure to do so can result in back or other injury.
Option A, Countertop Attachment
Insert bracket
Tabs.must point
to the right
Remove the brackets from the package and insert into the open
slots on the left and right-hand top of the dishwasher collar as
shown.
Using a pair of pliers, bend the tab down to secure the bracket
in place. Repeat this step for the other side.
NOTE: Do not attach the dishwasher. This will be done later.
1 | Stand dishwasher upright
Using 2 or more people, stand the dishwasher up.
IMPORTANT: The dishwasher must be secured to the cabinet.
There are two brackets found in the parts bag. Attach the
brackets using Option A if the countertop is wood, laminate or
another similar surface. If your countertop is marble, granite or
another hard surface, install using Option B.
Option B, Side Attachment
For marble, granite, or other hard surface countertops
With another person holding the rear of the dishwasher to keep
it from tipping, open dishwasher door and place towel over
pump assembly and spray arm of dishwasher. This will keep
screws from falling into pump area when you are securing
dishwasher to cabinet.
1 | Remove plastic buttons
ms
Plastic
button
Push the plastic buttons out of the side of the tub.
NOTE: Save the buttons to cover the holes after dishwasher is
installed.
15