Connect To Water Supply - Sears Kenmore W10435038B Instruction Manual

Check for plumb and
Check that leveling legs are firmly against the floor. Close and
latch the door, and place level against the front panel. Check
that dishwasher is centered from front to back in the opening. If
needed, adjust leveling leg until dishwasher is plumb. Repeat for
other side of dishwasher.
Helpful Tip: Push up on front of dishwasher to raise dishwasher
off the ground to adjust front legs. With some installations, it
may be easier to adjust the front leg using the %16" hex head
socket or adjustable wrench.
Preferred method Optional method
Check level side-to-side and
adjust legs if needed
Place level against top front opening of tub. Check that
dishwasher is level from side-to-side. If dishwasher is not level,
adjust front legs up or down until dishwasher is level. Close the
dishwasher door.
18
7" apne' b o pl ecune 1 ee
Connect to Water Supply
1 | Tighten 90° elbow fitting to valve
Be sure rubber washer is properly seated in fitting. Slide the
34" fitting up to the valve and hand tighten to avoid cross-
threading. Hand tighten until the coupling is tight.
Using pliers, check the tightness of the coupling. An additional
Ya to V2 turn may be required to seal the rubber gasket.
NOTE: Do not overtighten. Damage to the coupling can result.
Place paper towel under 90° elbow fitting. Turn on water supply
and check for leaks. If leak occurs, repeat previous step.
Black drain hose
connector
Drain hose stop
Stop
Place towel under drain hose to catch any water in drain hose.
Place the small drain hose clamp onto the small end of the drain
hose. Push the new drain hose into the black drain hose
connector up to the drain hose stop.