Check Operation; If Dishwasher Does Not Operate; Additional Tips - Sears Kenmore W10435038B Instruction Manual

w t
Electrical Shock Hazard
Plug into a grounded 3 prong outlet.
Do not remove ground prong.
Do not use an adapter.
Do not use an extension cord.
Failure to follow these instructions can result in death,
fire, or electrical shock.
Power supply cord—Plug into
a grounded 3 prong outlet
Plug into a grounded 3 prong outlet. Check that power supply
cord does not touch dishwasher motor or lower part of
dishwasher tub.
Reconnect Power
E Reconnect power }
Reconnect electrical power at the fuse box or circuit
breaker box.
Check Operation
m Read the Dishwasher User Instructions that came with your
dishwasher.
m Check that all parts have been installed and no steps were
skipped. Check that you have all tools used.
m= Start dishwasher and allow it to complete the shortest wash
cycle. After the first 2 minutes, unlatch door, wait 5 seconds,
then open door. Check that there is water in the bottom of
the dishwasher tub. Check that dishwasher is working
properly.
If the dishwasher is not working properly, disconnect power or
unplug dishwasher and see "If Dishwasher Does Not Operate"
section.
if Dishwasher Does Not Opera
First try the solutions suggested here to possibly avoid the cost
of a service call.
m= Has the circuit breaker tripped or the house fuse blown?
m= Is the door closed tightly and latched?
m= Has the cycle been set correctly to start the dishwasher?
m ls the water turned on?
If none of these possible solutions work, call 1-800-4-MY-HOME
(1-800-469-4663).
Additional Tips
Congratulations on purchasing your water
and energy efficient dishwasher! This
dishwasher cleans by spraying the dishes
with water and pauses to allow the
detergent to soak into and release the soils
on the dishes. The cycles are longer due to
the soak and the pauses for exceptional
cleaning. Models with SmartWash® =
contain an optical water sensor. The optical
water sensor is used to determine the optimum water and
energy consumption for great cleaning performance. The first
cycle using the sensor will run longer to calibrate the optical
sensor.
Rinse Aid is necessary for good drying results:
This dishwasher is designed to be used with rinse aid for good
drying performance and controlling the buildup of hard water
deposits. Energy efficient dishwashers use less water and
energy, so they depend on the water sheeting action of rinse aid
for good drying performance.
Start/Resume light may flash:
When pressing Start/Resume, you must make sure the door is
closed within 3 seconds. If you do not close the door within
3 seconds, the Start/Resume light will flash until you press it
again. (You must also do this when adding a dish during the
middle of a cycle.)
NOTE: If a braided supply hose is used, replace inlet hose after
5 years to reduce the risk of hose failure. Record hose
installation or replacement dates on the hose for future
reference.
23