Sears Kenmore W10435038B Instruction Manual page 10

3 Connect drain hose
Connect drain hose to waste-tee or waste disposer
using one of the following options:
¢ Option A, Waste disposer — no air gap
* Option B, No waste disposer — no air gap
* Option C, Waste.disposer— with air gap
¢ Option D, No waste disposer — with air gap
IMPORTANT: The drain hose connection of the disposer or a
waste tee must be made before the drain trap and at least
20" (50.8 cm) above the floor where the dishwasher will be
installed.
Helpful Tip: To reduce vibration of the hose, keep the hose away
from the floor.
|. Fit rubber end of drain hose to
waste tee and cut if needed.
NOTE: Do not cut ribbed section.
2. Attach rubber end of drain hose to
waste tee with a large drain hose
clamp (provided). Use pliers to
squeeze clamp open and move into
position. If the drain hose was cut,
use a 1%" to 2" (3.8 to 5 cm) screw-
type clamp (not provided).
Option C, Waste disposer — with air gap
Option A, Waste disposer ~ no air gap
er —no air gap
Large drain.
hose clamp —
Waste dispos
Drain hose
"Drain trap :
1. Using a hammer and screwdriver,
knock plug into disposer.
2. Use needle-nose pliers to remove
plug.
3. Attach drain hose to disposer inlet
with large drain hose clamp
(provided). Use pliers to squeeze
clamp open and move into position.
No waste disposer — no air gap
= Large drain ~~.
hose clamp
10
Rubber hose
connector
Drain hose
Drain trap
1. Using a hammer and screwdriver,
knock plug into disposer.
2. Use needle-nose pliers to remove
plug.
3. Connect rubber end of drain hose
to air gap and cut if needed.
NOTE: Do not cut ribbed section.
4, Attach drain hose to air gap with
large drain hose clamp (provided).
Use pliers to squeeze clamp open
and move into position. If the drain
hose was cut, use a 1%" to 2" (3.8 to
5 cm) screw-type clamp (not
provided).
5. Use a rubber hose (not provided)
with screw-type clamps (not
provided) to connect from air gap
to disposer inlet.