Service; Storage And Transportation; Disposal - DNIPRO M DHR-200 Safety And Operating Instructions Manual

en
WARN ING!
The operating mode switch can on-
ly be used when the motor of the
power tool is completely stopped.
If necessary, fix the processed material.
With the help of a clamping device or a
vice, the processed material is fixed more
reliably.
WARN ING!
Excessive pressure on the power
tool does not lead to faster perfor-
mance of work, but on the contrary
reduces productivity and can cause
a reduction in the service life of the
perforator.
Safety clutch (DHR-200BC ULTRA,
DHR-201BC Compact)
If the attachment is stuck in the processed
material, the safety clutch will work,
which disconnects the motor and the at-
tachment. If the accessory is jammed, im-
mediately release the power button of
the perforator and disconnect it from the
battery, remove the accessory from the
material being processed, check the op-
eration of the power tool, and only then
continue working with the hammer drill.
WARN ING!
The safety clutch works only if the
power tool is securely held. If the
power tool is held with one hand or
by the body, the safety clutch may
not work! This can lead to injury!
The manufacturer is not responsible
for the consequences caused by im-
proper use of the power tool!
10.

SERVICE

Regularly (preferably after each use) wipe
the body of the power tool with a soft
cloth. Make sure that there is no dirt and
dust in the ventilation holes. If the vents
are heavily soiled, blow them out with
compressed air.
Do not use solvents such as petrol, aque-
ous ammonia solution, etc., as they may
damage the plastic parts of the power
12
tool.
Make sure that moisture does not get into
the openings on the body of the power
tool.
Have the power tool repaired only by
the manufacturer (DNIPRO M LLC), the
DNIPRO-M authorised service centre or
the seller of the product.
Independent intervention in the internal
structure will lead to the removal of the
power tool from
11. STORAGE AND
TRANSPORTATION
It is recommended to store the power
tool in a dry place inaccessible to chil-
dren, protecting it from direct sunlight, at
a temperature from -20 °C to +50 °C and
a relative humidity of no more than 80%.
If you have stored or transported the
power tool at a temperature lower than
that at which it is planned to be used,
you must make sure that there is no con-
densation on the power tool. If conden-
sation forms on the power tool, its further
preparation for work or operation is pro-
hibited until the condensate dries com-
pletely.
It is recommended to keep the power
tool, the original safety and operating in-
structions and accessories in the packag-
ing. In this case, all necessary information
and components will always be available.
Transport the perforator in packaging
that prevents damage to the power tool.
The service life of the power tool is 5
years from the date of sale.
12.

DISPOSAL

Do not dispose of power tools with
household waste!
Power tools that have been decommis-
sioned are subject to separate storage
and disposal in accordance with environ-
mental legislation.
EU-DHR0823001-0823002