Electrical Connections - Hinkley SWELL FLUSH Instruction Manual

ELECTRICAL CONNECTIONS

REMEMBER -Turn off the power! NOTE - Control must be installed
within 30 feet of fan.
WARNINGS: Check to see that all connections are tight, including
ground, and that no bare wire is visible at the wire nuts, except for
the ground wire.
WARNINGS: To reduce the risk of electric shock, this fan must be
installed with an isolating wall control/switch. Turning off the
isolating wall switch can override any smart enabled or remote
operation commands.
1. For best performance, make sure the Black Antenna and WIFI
Antenna, on the end of the controller, remains extended and not
tangled with any of the electrical wires.
2. Connect the wiring from the ceiling to the controller unit. (Use the
2 wire bundle on the receiver.) Secure with supplied wire nuts.
•
Connect the BLACK building supply wire to the BLACK controller
wire.
•
Connect the WHITE controller neutral wire to the WHITE building
neutral wire.
•
Connect the COPPER building ground wire to the 2 YELLOW/
GREEN ground wires from the fan and controller.
Turn the wire nut connections upward, spreading them apart so the
green (ground) and white wires will be on one side of the outlet box
and the black wire will be on the other side.
BLK (AC IN)
WH (AC IN)
RECEIVER
Fig. 1
GROUND
OUTLET BOX
CEILING
FAN
©2023 Hinkley Lighting, Inc. | hinkley.com 07