Squeegee Incidence Set Up - Kruger KF38BBC Use And Maintenance

11.1.g - Squeegee incidence set up
(Fig. 20)
- Lower the squeegee using the specific
lever.
- Start the suction unit and advance for
some metres before stopping the suction
unit and the machine.
- Check the angle of incidence of the rub-
bers (66) on the floor.
Fig. A = too squatted
Fig. B = too high
Fig. C = correct position.
- Take off the squeegee from the machine.
- To set up, loosen the screw (70) of the
wheel (71) and move the wheel vertically
in the slot; by lifting the wheel, the angle
of incidence increases, viceversa it de-
creases.
11.1.h - Replacing
(KF38BBC) (Fig. 21)
WARNING:
Replace the blown fuse with one with the
same amperage.
- Pull the plug (21).
- Unscrew the two bolts (72) that fasten the
external box (73) and remove it.
- Unscrew the two bolts (74) of the printed
circuit board (75) and remove it.
Fuse (76) Green 30A
Machine general protection.
- Put the cover (75) and the box (73) back
into place in reverse sequence.
the fuses
ENGLISH - 12