Electrical Connection (Kf38E; Assembling The Brush; Charging The Battery - Kruger KF38BBC Use And Maintenance

4.1.c - Electrical connection (KF38E)
(Fig. 6)
- Mount the snap hook with cable (37) on
the handle (1).
- Insert the extension cable (42) (if pre-
sent) in the anti-tear hook (38), blocking it
as shown in the figure.
- Secure the hook (38) to the snap hook
(37) and connect the socket (43) of the
extension (42) to the plug (44) of the ma-
chine.
- Connect the power cord to an outlet hav-
ing minimum capacity of 10A.
WARNING:
- Make sure that the mains system is
equipped with an RCD (circuit breaker).
- Unwind the electric power cable com-
pletely before operating the appliance.
- Use an electrical extension lead only
if in perfect condition; ensure that the
section is appropriate for the appliance
power rating.
- Never let the power cable run over
sharp edges and do not tread on it.
4.1.d - Assembling the brush (Fig. 7)
- Position the brush (35) on the ground.
- Lift the front of the machine up by lever-
ing the handle (1 Fig. 1) and remove the
polystyrene support (45).
- Position the flange (12) above the brush
(35).
- Press the button (26 Fig. 1) that illumi-
nates, then, for starting the rotation of
the brush, press the levers (4 Fig. 1) until
hearing the coupling "Click" of the attach-
ment of the brush, then release levers (4
Fig. 1) and press the button (26 Fig. 1)
and the light turns off.
WARNING:
Use only brushes provided by the manu-
facturer according to the model of the ma-
chine.
Using other types of brushes may com-
promise the safety of the machine.
5.1 CHARGING THE
BATTERY (Fig. 8 - 9)
DANGER:
Charge the batteries in well-ventilated ar-
eas which comply with standards in force
in the country of use.
For safety-related information, follow
what is described in chapter 1 of this
manual.
WARNING:
For information and warnings about the
battery and the battery charger, follow
what is described in the battery and bat-
tery charger manual enclosed with this
document.
WARNING:
Check that the mains voltage is compat-
ible with the operating voltage of the bat-
tery charger.
- Move the machine near a main electrical
socket.
- Unwind the cable (46) and connect it to
the outlet.
- Leave the batteries to charge until the
"Green" LED (47) comes on, then re-
move the power cable (46) and wind it
up in the specific support.
NOTE:
(for GEL batteries only) 10 hours are
needed for complete battery charging.
Avoid partial recharges.
ENGLISH - 5