Machine Handling; Filling The Tank; Operation; Checks Before Use - Kruger KF38BBC Use And Maintenance

7.2 MACHINE HANDLING

(Fig. 1)
- To move the machine, lift the wiper (14)
and place the wheel (22) in the parking
position as indicated in the respective
paragraphs.
- Move the machine by pushing its handle
(1).

8.1 FILLING THE TANK

(Fig. 11)
WARNING:
Only add clean mains water to the tank at
a temperature no greater than 50°C.
- Remove the hose (30) supplied, connect
one end (30a) to a tap and insert the oth-
er end (30b) in the tank (9).
- Turn on the tap and fill the tank (9).
- Pour the liquid detergent into the tank.
NOTE:
Use non-foamy detergents only. For the
quantities, follow the instructions provided by
the detergent manufacturer according to the
type of dirt.
DANGER:
If the detergent comes in contact with the
eyes and/or skin or if swallowed, refer to
the use and safety information booklet
provided by the manufacturer of the de-
tergent.
- Once tank filling is complete, it is possible
to:
Insert the hose (30) into the tank (9) fully
where the end (30a) acts as a cap; or re-
move the hose (30) fully and insert the
filter (33) supplied into the tank (9) open-
ing.

9.1 OPERATION

9.1.a - Checks before use (Fig. 12)
- Check that the exhaust tube (15) of the
recovery tank is properly coupled and
properly sealed.
- Check that the squeegee water aspira-
tion hose (16) is correctly inserted in the
recovery tank.
- Check that the connector (53) on the
squeegee (14) is not blocked and that the
hose is connected correctly.
- To check the status of the battery charge;
press the switch (26), controlling the
LEDs (24) indicator (KF38BBC).
9.1.b - Preparing the machine and
choosing the cycle (Fig. 12)
- Press the button (26) that illuminates.
- Lower the wiper (14), using the pedal (3),
releasing it from its coupling.
- The machine can perform 4 working cy-
cles:
Drying only cycle:
- To perform the drying cycle only, press
button (25). The aspirator starts up.
Brushing only cycle:
- To effect only the brushing cycle, press
the levers (4), releasing the levers (4)
stops the brush.
Washing, brushing cycle:
- Press the button (27) to prepare for the
dispensing of water, then press levers (4)
to start the cycle.
Washing, brushing, drying cycle:
- Press the button (25) to start the aspira-
tor, the button (27) to prepare the dis-
pensing of water, then press the levers
(4) to start the cycle.
ENGLISH - 7