Features; Assembly - Breville Smart Air Viral Protect Max Instruction Book

Features

YOUR BREVILLE AIR PURIFIER
Your Breville Purifier improves your indoor air
quality using 4 distinct levels of protection, 3
built into the Breville AntiViral Filter including:
1. Pre-filter
For dust & pet dander.
2. AntiViral HEPA-13 filter
For fine airborne particles, allergens and
virus reduction including SARS-CoV-2 viral
particles and H1N1 & H3N2 particles.
3. Activated carbon filter
For odours and smoke.
4. Microbe Shield™ light
For bacteria and viruses.
CADR; stands for Clean Air Delivery Rate.
The CADR metric is a measurement of the
clean air volume that a purifier can provide
in a fixed amount of time – ultimately a
measurement of speed. It measures the amount
of filtered air passed through a purifier.
† CADR is tested according to GB/T 18801-2015.
Room size effective area is calculated using
NRCC-54013-2011 standard.
8

Assembly

BEFORE FIRST USE
• Remove and safely discard any packaging
material or promotional labels attached to
your air purifier and filter.
• Remove the filter from the air purifier
(see REPLACING THE FILTER in the Care,
Cleaning & Storage section of this book),
remove the protective packaging, then refit
the filter into the purifier.
• Select a flat and level location for the
air purifier.
• For proper air flow, locate the unit at least
20cm from any wall or furniture.
• Ensure the air inlet and outlets are not
blocked before use.
• Ensure the filter has been fitted correctly and
the base is locked as per the instructions in
this book.
• Plug the power plug into a 230V or 240V
power outlet and turn on the power outlet.
• All lights on the purifier will illuminate for
2 seconds, except for the light under the
Wi-Fi symbol, which will begin to flash fast.
The purifier is now in standby mode.
IMPORTANT
When moving the air purifier, always lift
the unit using two hands and set down
gently on a flat and level surface.