Table of Contents
Advertisement
FAN SPEED/TURBO MODE
NOTE
The air purifier will resume in the last
programmed setting before it was turned off,
even if turned off at the power outlet.
• Press the
FAN SPEED button until the
desired speed on the speed bar is illuminated
on the control panel.
• There are 4 fan speeds: Low, Medium, High
and Turbo.
• The selected fan speed is reflected on the
LED screen as illuminated dots. Low is 1 dot,
Medium is 2 dots, High is 3 dots and Turbo
is 4 dots.
NOTE
When changing the fan speed, the unit may
take a few seconds to adjust.
TIMER
• The air purifier can be set to operate between
0 - 12 hours, stopping automatically when
the selected operating time has elapsed. If no
timer is set, the air purifier will continuously
operate until it is manually switched off.
• Press the
TIMER button repeatedly until
the desired hour is displayed on the LED
display screen.
• For continuous operation, press the
TIMER button repeatedly until the LED
screen shows '0'.
10
AUTO MODE
• When in Auto mode, the air purifier will
automatically adjust the speed to help filter
the air based on the sensor reading.
• Press the AUTO button to turn AUTO on.
The AUTO button will illuminate.
• Press the AUTO button again, to turn Auto
off; the AUTO light will extinguish.
FILTER RESET
• The
button will illuminate to indicate
filter replacement is required.
• Replace the filter according to the directions
found under Replacing the Filter in this book.
• Once the filter is replaced, press the
button to reset
• the Filter Reset light.
• The built-in timer for the filter reset is 4,320
operating hours.
NOTE
Recommended monthly cleaning is advised
for maintaining performance as per the
instructions found in the Care, Cleaning &
Storage section of this book. For optimal filter
performance change between 6 -12 months
and at the start key seasonal allergy seasons
such as spring.
Advertisement
Table of Contents
