Assembly Instructions - Project Source 58101-X5501 Manual

ASSEMBLY INSTRUCTIONS

1. Remove the existing showerhead by turning it in a
counterclockwise direction. Note: A wrench (not included)
may be required. Clean any debris or old thread sealant
from the threads of the shower arm after the showerhead
has been removed.
2. The slide bar (A) can be mounted using the preassembled
suction cup or by using an optional adhesive pad
by using mounting screws (DD) to attach permanently.
The suction cup
smooth, flat surfaces. If your shower wall has a rough
surface or if there is a grout line present,
the mounting screws
2.1 and 2.2. Note: Some tub-surrounds will appear to have
a smooth, flat surface, but will actually have light texture
that is not noticeable at first. If this is the case,
the suction cup and adhesive pad from maintaining a hold
and you will need to use
2.1. Mark location of holes as shown in diagram 2.1.
2.1a. If mounting into stud, fasten adhesive pad (AA) into wall
with mounting screws (DD).
2.1b. If mounting into drywall, drill 1/4 in. pilot holes into the
wall and insert plastic anchors (CC) with Phillips screwdriver
(not included). Insert mounting screws (DD) through adhesive
pad (AA) and into plastic anchors (CC).
Remove the suction cup and plastic ring from slide bar (A)
by turning it in a counterclockwise direction as shown in
diagram 2.2.
2.1a
Stud
AA
and adhesive pad can only be used on
(DD) to attach,
the mounting screws (DD) to
2.1b
DD
(AA), or
you'll need to use
as described in steps
it will prevent
attach.
Drywall
CC
DD
AA
5
1
2
A
2.1
2.2
A