Summary of Contents for Project Source 67423W-6004
Page 1
ITEM # 5667889 / 5649410 / 5667891 MODEL # 67423W-6004 / 67423W-607001 67423W-604408 Single-Handle Bath Faucet Español p. 10 PROJECT SOURCE and logo design are trademarks or ATTACH YOUR RECEIPT HERE registered trademarks of LF, LLC. All rights reserved. Serial Number Purchase Date Thank you for purchasing this PROJECT SOURCE product.
TABLE OF CONTENTS Package Contents..........................Safety Information..........................Preparation............................. Assembly or Installation Instructions...................... Operating Instructions..........................Care and Maintenance........................... Troubleshooting............................Warranty..............................Replacement Parts List..........................
SAFETY INFORMATION Please read and understand this entire manual before attempting to assemble, operate, or install the product. WARNING • Follow the installation instructions carefully. Proper installation is the installer’s responsibility. • Failure to follow correct installation procedures can result in the faucet being loose, which can result in serious injury.
Page 5
ASSEMBLY INSTRUCTIONS 1b. Optional Deckplate Installation: Shut off the water supply. Remove the old faucet. Clean the mounting surface. Before installing the new faucet, remove the screw protection sleeves from the inlet tube. Place the deckplate (B) and the gasket (C) on the bottom of the new faucet assembly (A).
Page 6
POP-UP DRAIN INSTRUCTIONS 1. Remove the bottom gasket (3) and nut (4) from the top gasket (1) and pop-up body (2). Attach these pieces together by pushing the bottom gasket (3) down into the top of the nut (4) and twisting together. 2.
OPERATION INSTRUCTIONS Flushing and checking for leaks: Important: After installation is complete, remove the aerator (2) with wrench (H) to flush the water lines. Turn on the water supply and allow both hot and cold water to run for at least one minute each. This flushes away any debris that could cause damage to internal parts.
CARE AND MAINTENANCE • Clean carefully by gently wiping with a grit-free damp cloth. • Use only mild soap with water. • Never use acids, harsh chemicals, or abrasive detergents to clean the faucet surface. TROUBLESHOOTING PROBLEM POSSIBLE CAUSE CORRECTIVE ACTION There are leaks The bonnet nut has come loose and Tighten the bonnet nut.
WARRANTY This faucet has been manufactured under the highest standard of workmanship. All parts of this faucet are warranted to be free from leaks or drips during domestic use for as long as the original purchaser owns this product. THIS EXCLUDES INDUSTRIAL, COMMERCIAL, OR BUSINESS USE. The manufacturer will replace FREE OF CHARGE, under the warranty conditions the entire unit or any part (at our option) which proves defective in material and/or workmanship under normal installation, use and service.
Page 10
MODELO # 67423W-6004 / 67423W-607001 67423W-604408 Grifo para baño de una sola manija ADJUNTE SU RECIBO AQUÍ PROJECT SOURCE y el diseño del logotipo son marcas comerciales o marcas comerciales registradas de LF, LLC. Todos los derechos reservados. Número de serie Fecha de compra Gracias por comprar este producto PROJECT SOURCE.
Page 11
ÍNDICE Contenido del paquete..........................Información de seguridad........................Preparación............................. Instrucciones de ensamblaje........................Instrucciones de funcionamiento......................Cuidado y mantenimiento........................Solución de problemas..........................Garantía..............................Lista de piezas de repuesto........................
INFORMACIÓN DE SEGURIDAD Lea y comprenda completamente este manual antes de intentar ensamblar, usar o instalar el producto. ADVERTENCIA • Siga atentamente las instrucciones de instalación. El instalador tiene la responsabilidad de realizar una instalación adecuada. • Si no sigue los procedimientos correctos de instalación el grifo puede soltarse y provocar lesiones graves.
Page 14
INSTRUCCIONES DE ENSAMBLAJE 1b. Instalación opcional con placa de cubierta: Cierre el suministro de agua. Retire el grifo viejo. Limpie la superficie de montaje. Antes de instalar el grifo nuevo, retire las fundas protectoras de los tornillos del tubo de entrada. Coloque la placa de cubierta (B) y el empaque (C) en la parte inferior del ensamble del grifo nuevo (A).
Page 15
Instalación del drenaje emergente 1. Retire el empaque inferior (3) y la tuerca (4) del empaque superior (1) y del cuerpo emergente (2). Sujete las dos piezas empujando el empaque inferior (3) hacia abajo en la parte superior de la tuerca (4) y enroscándolas juntas.
INSTRUCCIONES DE FUNCIONAMIENTO Cómo purgar las tuberías y comprobar que no haya fugas: Importante: cuando la instalación esté completa, retire el aireador (2) con una llave (H) para descargar las líneas de suministro. Abra el suministro de agua y deje correr agua fría y caliente durante al menos un minuto cada una.
CUIDADO Y MANTENIMIENTO • Limpie cuidadosa y suavemente con un paño limpio. • Lave solo con agua y jabón suave. • Nunca limpie la superficie con ácidos, agentes químicos fuertes ni detergentes abrasivos. SOLUCIÓN DE PROBLEMAS PROBLEMA CAUSA POSIBLE ACCIÓN CORRECTIVA Hay filtraciones La tuerca ciega se aflojó...
GARANTÍA Este grifo ha sido fabricado bajo los estándares de mano de obra más elevados. Todas las piezas de este grifo están garantizadas contra fugas o goteos durante el uso doméstico mientras lo posea el propietario original. ESTO EXCLUYE EL USO INDUSTRIAL, COMERCIAL O EN OFICINA. El fabricante reemplazará...
Need help?
Do you have a question about the 67423W-6004 and is the answer not in the manual?
Questions and answers