Ironing With Steam; Ironing Without Steam; "Sensorsecure" Function - Bosch TDA702821I Operating Instructions Manual

2.3 "AntiShine" function *
If this function is selected, the risk of shiny marks
on the garment due to the ironing is reduced.
When the "AntiShine" function is selected, the
blue light inside the temperature control comes
on.

3. Ironing with steam


See the leaflet sides
The steam regulator (3) is used to adjust the
amount of steam produced when ironing.
Temperature
control (12)
i-Temp
AntiShine
☞
Tip: For better ironing results, iron the last
strokes without steam to dry the garment.
4. Shot of steam
shot

See the leaflet sides
This can be used to remove stubborn
wrinkles or to press in a sharp crease or
pleat.
1. Set the temperature control (12) to "max".
2. Press the shot of steam button
repeatedly with intervals of at least 5 seconds.
16
B O SC H
1 2 3 max
1 2 3 max
Recommended position of
the steam regulator (3) *
• eco • max
• eco •
max
max
1 2 3
1 2 3 max
1 2 3 max
• eco • max
• eco • max
• eco • max
1 2 3 max
1 2 3 max
• eco • max
• eco • max
1 2 3 max
1 2 3 max
1 2 3 max
1 2 3 max
• eco •
max
• eco •
max
1 2 3 max
• eco • max
• eco • max
• eco • max
(2)
5. Vertical steam

See the leaflet sides
This can be used to remove creases from
hanging clothes, curtains etc.
1. Set the temperature control (12) to "max".
2. Hang article of clothing on a clothes hanger.
3. Operate the iron in a vertical position at a
distance of 10 cm / 4 in, and press the shot of
steam button
(2) repeatedly with pauses of
at least 5 seconds.

6. Ironing without steam


See the leaflet sides
This enables the iron to be used for dry
ironing.
Set steam regulator (3) to the
7. Drip protection *
DripStop

See the leaflet sides
lf the temperature is set too low, the steam is
automatically switched off to avoid dripping.
There may be an audible click when this occurs.
8. Spray

See the leaflet sides
This can be used to remove stubborn wrinkles.
Do not use the spray function with silk.

9. "SensorSecure" function


See the leaflet sides
The "SensorSecure" function switches off
the iron when the handle is no longer
gripped, thus increasing safety and saving
energy.
1. Plug in the iron.
2. "SensorSecure" light (14) flashes when
the handle is not gripped, and will show a
continuous light when the handle is gripped.
3. If the iron handle is released for more
than 10 seconds, the iron will stop heating
automatically.
position.
* Model dependent