Setting The Temperature; B Ironing With Steam - Bosch Sensixx B10L Operating Instructions Manual

Remark : if the boiler is empty, both
indicator lamps (6 and 7) may light up
simultaneously. Fill the boiler as indicated in
paragraph "Reilling the boiler".
reilling the boiler
Attention! Risk of burns!
Be careful when opening the cap, steam
may escape.
If the pilot lamp (7) illuminates :
1. Press the steam button (12) to check that
no more steam is generated. Only then the
boiler should be reilled.
2. Set the appliance switch (9) to the off
position ("0") and unplug the steam station
from the mains. Then wait for minimal 2
minutes.
3. Open the cap (1) carefully and slowly. Allow
remaining steam to escape.
4. Reill the boiler using always the funnel.
Do not overill the boiler.
5. If there is water left around the illing inlet,
please dry with a towel before closing the
boiler.
6. Close the cap irmly.
Important:
• Normal tap water can be used.
To prolong the optimum steam function, mix
tap water with distilled water 1:1. If the tap
water in your district is very hard, mix tap
water with distilled water 1:2.
You can inquire about the water hardness
with your local water supplier.
• To avoid damage and/or contamination
of the boiler, do not use perfumed water,
vinegar, starch, descaling agents, additives
or any other type of chemical product.
any damage caused by the use of the
aforementioned products, will make the
guarantee void.
• The iron is not designed to rest on its heal.
Please always position it horizontally on the
iron pad (2). The iron pad can be placed
into the specially designed recess on the
appliance or somewhere suitable alongside
the ironing area.
Never rest the iron on the appliance
without the iron pad!.
• During it irst use the iron may produce
certain vapours and odours, along with
white particles on the soleplate, this is
normal and it will stop after a few minutes
Setting the
temperature
1. Check the ironing instruction label on the
garment to determine the correct ironing
temperature.
2. Turn the temperature selector (11) to the
required setting:
•
Synthetics
••
Silk – Wool
•••
Cotton – Linen
3. The indicator lamp (13) will remain lit while
the iron is heating and go out as soon as the
iron has reached the selected temperature.
Tips:
• Sort your garments out based on their
cleaning symbol labels, always starting with
clothes that have to be ironed at the lowest
temperatures.
• If you are not sure what the garment
is made of then begin ironing at a low
temperature and decide on the correct
temperature by ironing a small section not
usually seen when worn
B
Ironing with steam
1. Turn the temperature selector (11) to the
required setting
2. Set the amount of steam to suit your
needs, using the variable steam control (8*)
(depending on the model).
3. Press the steam release button (12) to
release steam.
attention:
When ironing on a lower temperature setting "•".
• If the appliance has variable steam control
(8*), set the variable steam control to its
lowest position (" ").
• If the appliance does not have variable
steam control, press the steam release
button (12) only for a few seconds at a time
when ironing at lower temperatures.
15
B OS CH