Maintenance And Cleaning; General Cleaning Information - Beko BHCA66641BBHS User Manual

Aluminium filter fill warning
The light of Speed 2 key flashes for thirty
seconds after every 100 hours of operation.
Clean the aluminium filters. After cleaning,
the lamp warning of Speed 2 key does not
turn off automatically. This product contin-
ues to show the 30-second warning when
the product switches off after every opera-
tion. When you touch the Speed 2 key for
more than 3 seconds, aluminium filter fill
warning is reset and the lamp is turned off.
The warning is not cancelled if the
power is cut when the hood gives
aluminium filter fill warning. When
the power is available, it continues
to warn with the light of Speed 2
key flashing.
If you run the hood at any speed
level with the aluminium filter fill
warning, the warning will not ap-
pear for as long as the hood is run-
ning. When you turn off the hood,
the fill warning starts flashing again
for 30 seconds.
If you turn off the warning without
cleaning the aluminium filter, the
operating time of 100 hours is reset
and it starts over. At the end of the
next 100 hours, your hood warns
again.

6 Maintenance and Cleaning

6.1 General Cleaning Information

General warnings
• Wait for the product to cool before clean-
ing the product. Hot surfaces may cause
burns!
• Do not apply the detergents directly on
the hot surfaces. This may cause per-
manent stains.
• The product should be thoroughly
cleaned and dried after each operation.
Thus, food residues shall be easily
Carbon filter fill warning (for products with
carbon filter)
The light of Speed 2 key flashes for thirty
seconds after every 100 hours of operation.
In this case, you must replace your carbon
filter. Consult an authorized service for this.
After replacement, the lamp warning of
Speed 2 key does not turn off automatic-
ally. This product continues to show the 30-
second warning when the product switches
off after every operation. When you touch
the Speed 2 key for more than 3 seconds,
carbon filter fill warning is reset and the
lamp is turned off.
The warning is not cancelled if the
power is cut when the hood gives
carbon filter fill warning. When the
power is available, it continues to
warn with the light of Speed 2 key
flashing.
If you run your hood at any speed
level with the carbon filter fill warn-
ing, the warning will not appear for
as long as the hood is running.
When you turn off the hood, the fill
warning starts flashing again for 30
seconds.
If you turn off the warning without
replacing the carbon filter, the oper-
ating time of 100 hours is reset and
it starts over. At the end of the next
100 hours, warning is given again.
cleaned and these residues shall be pre-
vented from burning when the product is
used again later. Thus, the service life of
the appliance extends and frequently
faced problems are decreased.
• Do not use steam cleaning products for
cleaning.
• Some detergents or cleaning agents
cause damage to the surface. Unsuitable
cleaning agents are: bleach, cleaning
products containing ammonia, acid or
chloride, steam cleaning products, de-
EN / 16
EN
DE
PL
ES