Table of Contents
Advertisement
AUTO mode
02.
Note: This appliance must be connected to a power supply providing electricity 24 hours per day. This
mode is designed to automatically operate the heat pump when the temperature has dropped by a
specified amount, just like a thermostatically controlled hot water cylinder.
AUTO Mode (under default settings)
1. Turn on the appliance by pressing the
_
2. Press the MODE keys until the display shows the AUTO icon.
_ _
+
–
3. Press the
or
key to adjust the temperature to the desired settings as described in step
60℃ is recommended.
_ _ _
4. Your appliance should begin to operate in AUTO mode to reach the set temperature. It may take up to 5
minutes for the heat pump to initiate operation.
_ _ _ _
5. If hot water is required as soon as possible after installation, the BOOST
element in addition to the heat pump for a faster recovery. This is not a working mode but will assist until the set
temperature is reached, returning to the previous working mode. As this is an energy efficient appliance, the heat
pump should remain the main source of heating wherever possible.
_ _ _ _ _
6. Your appliance should reach the set temperature and hot water will be available for use.
_ _ _ _ _ _
7. The default temperature differential is 10℃ for the HP200 model and 9℃ for the HP250 model. This means that
at any time of the day or night, when the actual water temperature drops by this amount below the set
temperature, the heat pump will operate. The temperature differential can be adjusted in the Service mode further
in this guide.
ELEC mode
03.
Note: This mode is designed to provide heating if the heat pump is not operating for any reason.
If there is a fault with the heat pump module, follow this guide to ensure available hot water until a
technician can resolve the issue.
1. Turn on the appliance by pressing the
_
2. Press the MODE keys until the display shows the ELEC icon.
_ _
3. The water heater should now heat via the electric element until the set temperature is reached.
The element icon
_ _ _
4. If there is a fault with the heat pump module, call Fisher & Paykel for service support.
will be displayed to indicate its operation.
key.
key if in Standby, otherwise disregard this step.
ELEC
. A minimum of
01.1
key can operate the electric
Advertisement
Table of Contents
