Remote Controller Preparation - Autel Robotics Explorer EVO II Manual

:i Remark
• The batteries of the aircraft and the remote controller shall be always fully charged before
flying.
•
A[ most 90 minutes are required to fully chuge the aircraft battery, and approximately 120
minutes are required for the remote controller.
•
After charging is complete, disconnect the charger from the aircraft battery/remote controller.
3.2 Remote controller preparation
3.2.1 Extend remote controller
'Ihe remote control is folded in the packing box. Please extend [he antenna before use.
• Antenna position adjustment
Please refer to Section 2.2.2.
3.2.2 Turn oWoff remote controller
•
Power on/off
Press and hold the power button for 2s until you hear a short beep.
e Important
•
Before the aircraft power switch is tamed on, always tam on the remote control fist.
•
Before the remote controller is turned off, always tam off the aircraft power switch first.
3.2.3 Aircraft and remote controller pairing
The remote controller and the aircraft have been paired in factory. If they need to be paired again,
please refer to Section 2.2.2 ( ).
41