Assembly; Operation - RedMax HBZ260R Operator's Manual

To do a check of the start/stop switch
1. Use the start/stop switch to stop the engine.
2. Make sure that the engine stops fully.
To see where the start/stop switch is on your product,
Product overview on page 2 .
refer to
Fuel safety
WARNING:
instructions that follow before you use the
product.
• Do not mix or add the fuel indoors or near a heat
source.
• Do not start the product if there is fuel or oil on the
product or on your body.
• Do not start the product if the engine has a fuel leak.
Examine the engine for fuel leaks regularly.
• Always be careful with fuel. Fuel is flammable and
the fuel fumes are explosive and can cause serious
injury or death.
• Do not breathe in the fuel fumes, it can cause injury.
Make sure that there is a sufficient airflow.
Introduction
WARNING:
safety chapter before you assemble the
product.
To assemble the blower pipe
1. Loosen the clamp screw (A).
D
Introduction
WARNING:
safety chapter before you use the product.
6
Read the warning
Read and understand the
A
C
B
Read and understand the
• Do not smoke near the fuel or the engine.
• Do not put the product or a fuel container near warm
objects, an open flame, a spark or a pilot light.
• Always use approved containers for storage and
transportation of fuel.
Safety instructions for maintenance
WARNING:
instructions that follow before you use the
product.
• Stop the engine, remove the spark plug and let
the engine become cool before maintenance and

assembly.

• A blocked spark arrestor screen causes the engine
to become too hot which causes damage to the
engine.
• If the spark arrestor screen is frequently blocked,
it can be a sign that performance of the catalytic
converter is decreased. Speak to your servicing
dealer to examine the muffler.
Assembly
2. Install the intermediate pipe (B) to the blower pipe
(C).
3. Install and tighten the clamp screw (A) .
4. Install the round nozzle (D) to the intermediate pipe.

Operation

Fuel
This product has a two-stroke engine.
Read the warning
2416 - 001 - 08.03.2024