EMS fusion FCX-532-001 Installation Manual

Loop Module
Installation Guide
POWER
FAULT
ISOLATOR
ACTIVE
1 Pre installation
Installation must conform to applicable local installation
!
codes and should only be installed by a fully trained
competent person.
Ensure the loop module is installed as per the site survey.
Refer to step 3 to ensure optimised wireless performance.
If using remote aerials with this product, refer to the remote
aerial installation guide for more information.
A maximum of 5 loop modules can be connected per loop.
This device contains electronics that may be susceptible to
damage from Electrostatic Discharge (ESD). Take appropriate
precautions when handling electronic boards.
3 Mounting location guidelines
For optimum wireless
p e r f o r m a n c e , t h e
following must
observed:
Ensure the loop module is not
installed within 2 m of other
wireless or electrical equipment
(not including the
panel).
Ensure the loop module is not
installed within 0.6 m of metal
work.
5 Remove cable entry points
Drill the cable entry
points as necessary.
= DO NOT use
= Available cable
entry points
©2021 EMS Ltd. All rights reserved
F usion
2 m
be
0.6 m
Loop
POWER
FAULT
ISOLATOR
module ACTIVE
control
FIRE
Control
panel
Fire Alarm Control
Part no
FCX-532-001
2 Components
1 2 3
1
4x corner covers
4
Loop module PCB
4 Optional PCB removal
Remove the three circled retaining screws, before unclipping
the PCB.
ISOLATE
6 Fix to the wall
All five circled
fixing positions
are available for
use as required.
The key hole
can also be used
for locating and
fixing where
required.
Page 1 of 2
Product description
Fusion Loop Module
2 3
4x lid screws Loop module lid
5
Loop module back box
ON
1 2 3 4 5 6 7 8
TX RX
1 2 3 4 5 6 7
RADIO
RESET
0V
RX
HELP TX
3V
POWER
FAULT
WD
BACK
LOOP IN LOOP OUT
- -
TSD077-99 Iss 8 24/11/2021
4 5
AJM