AEG EHBZB User Manual page 18

11.3 Removing grill
WARNING!
There is a risk of burns.
1. Turn off the appliance and wait until it is
cold to clean it.
2. Remove the shelf supports.
3. Grab the grill corners. Pull it forwards
against the spring pressure and out of
two holders.
The grill folds down.
4. Clean the oven ceiling with warm water, a
soft cloth and a mild detergent. Let it dry.
5. Install the grill in the opposite sequence.
6. Install the shelf supports.
11.4 Removing and installing the
door
You can remove the door and the internal
glass panels to clean it. The number of glass
panels is different for different models.
WARNING!
The door is heavy.
CAUTION!
Carefully handle the glass, especially
around the edges of the front panel. The
glass can break.
1. Fully open the door.
2. Lift and press the clamping levers
the two door hinges.
18 ENGLISH
3. Close the oven door to the first opening
position (at approximate angle: 70°).
4. Hold the door with one hand on each side
and pull it away from the oven at an
upwards angle.
5. Put the door with the outer side down on
a soft cloth on a stable surface.
6. Hold the door trim
the door at the two sides and push
inwards to release the clip seal.
2
B
7. Pull the door trim to the front to remove it.
8. Hold the door glass panels on their top
edge one by one and pull them up out of
the guide.
9. Clean the glass panel with water and
soap. Dry the glass panel carefully. Do
not clean the glass panels in the
dishwasher.
After cleaning, do the above steps in the
on
opposite sequence. Install the smaller panel
first, then the larger and the door.
Make sure that the glasses are inserted in the
correct position otherwise the surface of the
door may overheat.
A
A
on the top edge of
1