Solplanet Ai-LB Pro Series Quick Installation Manual

Rechargeable Lithium-ion Battery System
Ai-LB 5K Pro Quick Installation Guide
Version: 1.5
Doc. No.: PT-Q-231C02
Date: 2023/07/05
© Copyright 2023 Solplanet Limited. All rights reserved. Specifications are subject to change without prior notice.
Solplanet does not accept any responsibility whatsoever for potential errors or possible lack of information in this document.
Before installation, Please read this guide.
1. Read this guide carefully before installation to understand product features and safety precautions.
2. Installers should be well trained to fully understand grid-connected photovoltaic power systems and
national/regional standards.
3. Installers must use insulated tools and wear safety equipment.
4. As required by local regulations,an overcurrent protection and isolation device that operates both positive
and negative conductors simultaneously is required between inverter and battery system and also between
parallel batteries.The cable needs to be prepared by the installer, cable specification: 25mm
cable terminal model: E25-16.
5. Before installation, ensure that battery pack is switched off, and open any associated circuit breakers and
disconnect switches.
1 Handling Precautions and Guidelines for Product
These Handling Precautions and Guidelines for Rechargeable Battery System ("Handling Precautions
and Guidelines") shall only apply to the packs manufactured by AISWEI New Energy Technology (Yangzhong)
Co., Ltd ( hereinafter referred to as "AISWEI" ). Customer shall strictly follow these Handling Precautions and
Guidelines, and shall alert its customers, contract manufacturers, agents, distributors, service providers and
end users of the risks of the packs and shall ensure that Customer's obligations as specified in the Document
as well as the Handling Precautions and Guidelines are, through a printed label on host device, or through
Customer's Quick Installation Guide, or a help file or Customer's Internet website, contractually imposed on
Customer's own customers and distributors, and by them further down to the end users so that the entire
chain is committed to the above obligations and so that the products are properly handled, operated,
transported, used and maintained.
Statement(1) :
Customer is requested to contact AISWEI in advance, if and when the customer needs other applications
or operating conditions than those described in this Document. Additional experimentation may be required
to verify performance and safety under such conditions
Statement (2) ：
AISWEI will take no responsibility for any accident or liabilities in the event the Product is used for
applications or under conditions other than those described in this Document.
⚫ Use Product under specified charge/discharge conditions.
⚫ Do not immerse in water.
⚫ Do not heat.
1
2
/ 4 AWG,