Advertisement
Lift up the middle frame and put it into a fixture, tear
S13
off all the cable tape and the mylar tape for releasing
the LED key board away from the middle frame.
Tear off 2pcs shading tapes and 1pcs acetate tape,
S14
and then disconnect the panel lamp cable from the
two connectors of the panel module.
Remove the mylar sheet from the hooks of the main
S15
bracket chassis.
5. Disassembly and Assembly Procedures
Use a Philips-head screwdriver to remove
screws for unlocking power board and interface
S20
board with the bracket.
(No.1 screw size=M4x8, Torque=5
No.2~9 screw size=M3x6, Torque=5
8
7
9
Remove the circuit boards from the
module, and then
S21
Philips-head screwdriver to remove
unlocking TBT board with interface board.
(No.1~3 screw size=M3x6, Torque=5±1kgfxcm)
9pcs
1kgfxcm;
±
1kgfxcm)
±
4
2
6
1
5
3
bracket chassis
disconnect all of the cables. Use a
3pcs
screws for
6
8
7
Advertisement
