Troubleshooting - Kärcher Admiral X Manual

Maintenance

Troubleshooting

PROBLEM
Is the cord plugged in.
Circuit breaker tripped in building.
No Power, Nothing
Runs
Faulty switch.
Faulty power cord or pigtail.
Vacuum circuit breaker tripped.
Faulty main vacuum switch.
Vacuum Motor Will
Not Run.
Loose wiring.
Faulty vac motor.
Debris lodged in vac shoe.
Dome gasket defective or missing.
Vacuum Motor Runs
Vacuum hose cracked or hose cuff loose.
But Suction Is Poor
Recovery tank full / float ball stuck in the up
position.
Main pump switch off.
Poor Or No Water
Jets clogged or missing.
Flow (Carpet Is
Streaky)
Solution filter clogged.
Faulty solenoid.
Brush switch off.
Brush circuit breaker tripped.
Brush Does Not
Spin
Brush belt broken.
Faulty brush motor.
30
CAUSE
8.645-740.0 Manual Operator - Admiral X/Admiral XL
SOLUTION
Plug in cord.
Reset breaker.
Call for service.
Call for service.
Reset breaker.
Call for service.
Call for service.
Call for service.
Remove debris from vac shoe.
Replace as necessary.
Replace or repair as necessary.
Turn off vac motor. Drain and rinse recovery
tank.
Turn on.
Clean using a vinegar /water solution or
replace.
Drain solution tank and clean solution filter.
Call for service.
Turn on brush switch.
Reset circuit breaker.
Replace as necessary.
Call for service.