Table of Contents
Advertisement
FIRST TIME LIGHTING INSTRUCTIONS
FOR YOUR SAFETY READ BEFORE LIGHTING
WARNING: If you do not follow these instructions exactly, a fire or explosion may result
causing property damage, personal injury, and loss of life.
Safety Information
•
This appliance is equipped with an ignition device which
automatically lights the pilot. Do not attempt to light pilot by
hand.
•
BEFORE OPERATING, smell all around appliance area for gas.
Be sure to smell next to the floor because some gas is heavier
than air and will settle on the floor.
•
Toggle Master Switch to ON. Remote Transmitter will not
communicate to receiver unless the Master Switch is ON.
•
Use only the supplied remote control to light the pilot. This valve
will not operate if the pilot is not lit and stable.
•
Do not use this appliance if any part has been underwater.
Immediately call a qualified service technician to inspect and
replace any component which has been under water.
Attempted operation may result in fire or explosion resulting in
property damage, personal injury, and loss of life.
Operating Instructions
1.
Stop! Read the above safety information carefully before proceeding!
2.
Do not attempt to light the pilot by hand; the door must remain on this
unit during pilot ignition, except for the "First Time Lighting".
3.
Press the ON/OFF Key on remote control to begin the ignition sequence.
4.
The wall receiver will emit an audible "beep"; after which the igniter will begin to
spark. After the pilot lights and is established, the valve will automatically open
and the burner will light. The burner will initially light to full flame. Adjust it to an
appealing setting with the remote. See Remote Operating Instructions in
Operating Instructions Manual.
5.
WARNING! If the pilot fails to light the system will "lockout". Press ON/OFF Key
on remote control to Turn Off the system. Allow five (5)minutes for any gas in
the unit to dissipate before attempting to re-light the pilot. SEE STEP "B"
ABOVE.
6.
Press ON/OFF Key on remote control again to start ignition sequence.
7.
If the appliance will not operate, follow the instructions "To Turn Off Gas To
Appliance" and call your service technician or gas supplier.
To Turn Off Gas to Appliance
1.
Press the ON/OFF button on the Remote Control Unit.
2.
Turn OFF the External Manual Shutoff Valve supplied by installer and mounted adjacent to appliance.
3.
To access the Gas Valve reference "Accessing the Gas Valve" section in the Owner's Manual.
4.
Turn OFF all electric power to the appliance if service is to be performed.
WHAT TO DO IF YOU SMELL GAS
•
Do not light any appliance.
•
Do not touch any light switch
•
Do not use any phone in your
building.
•
Call your gas supplier from a
neighbor's phone.
•
Follow the provider representative's
instructions.
•
If you cannot reach your gas
supplier, call the fire department for
assistance.
PAGE 34
REMOTE TRANSMITTER
BLUE LCD
DISPLAY
ON/OFF KEY
THERMOSTAT
SELECTION KEY
UP/DOWN
SELECTION KEY
MODE
SELECTION KEY
Advertisement
Table of Contents
