Advertisement
FR6800 User Guide
the FR6076 on page
When turning the FR6076 on for the first time, the splash screen displays for about a minute as the FR6076 initializes
its flash file system, then the calibration window appears. Note that these windows also appear upon cold boot.
When the FR6076 powers up after inserting a battery for the first time, the device boots and powers on
NOTE
automatically.
Calibrating the Screen
To calibrate the screen so the cursor on the touch screen aligns with the tip of the stylus:
Remove the stylus from its holder on the back of the FR6076.
1.
Carefully press and briefly hold the tip of stylus on the center of each target that appears on the screen.
2.
Repeat as the target moves around the screen, then tap the screen to continue.
3.
Checking Battery Status
To check the charge status of the main battery or backup battery in the FR6076, tap
icon to display the
Power
To save battery power, tap the
CF Card Installation
First unscrew the plastic cover, and remove it, insert CF card with the front facing up.
Micro Secure Digital (microSD) Card
The microSD card slot provides secondary non-volatile storage. The slot is located on the side of the FR6076 (see
Figure
1-7). Refer to the documentation provided with the card for more information, and follow the manufacturer's
recommendations for use.
CAUTION
To install the microSD card:
Power off the FR6076.
1.
2-14.
window.
Power
tab and set the FR6076 to turn off after a specified number of minutes.
Advanced
Follow proper ESD precautions to avoid damaging the microSD card. Proper ESD precautions
include, but are not limited to, working on an ESD mat and ensuring that the operator is properly
grounded.
18
Getting Started
>
>
tab >
Start
Settings
System
Advertisement
