Table of Contents
Advertisement
(10) Floppy drive Connector (34-pin block): FDD
This connector supports the provided floppy drive ribbon cable. After connecting the
single plug end to motherboard, connect the two plugs at other end to the floppy drives.
(11) Primary IDE Connector (40-pin block): IDE1
This connector supports the provided IDE hard disk ribbon cable. After connecting the
single plug end to motherboard, connect the two plugs at other end to your hard disk(s).
If you install two hard disks, you must configure the second drive to Slave mode by
setting its jumpers accordingly. Please refer to the documentation of your hard disk for
the jumper settings.
SPDIF RX1
PS/2
Mouse
PRINTER
PS/2
Keyboard
SPDIF RX2
FDD
Pin 1
Floppy Drive Connector
IDE1
Pin 1
Primary IDE Connector
17
Optional
Gigabit LAN
USB1
USB
COM1
Surrback
Line-IN
CEN/LFE
Line-OUT
MIC-IN
Surround
Advertisement
Table of Contents
